WICKED Kit de Cepillo de Limpieza de Tubos de Cobre de 1/2 Pulgada; Herramienta Profesional de Fontanero Industrial All Metal, Grado de construcción Resistente con Piezas reemplazables
5 valoraciones en WICKED Kit de Cepillo de Limpieza de Tubos de Cobre de 1/2 Pulgada; Herramienta Profesional de Fontanero Industrial All Metal, Grado de construcción Resistente con Piezas reemplazables
Andrew Choly –
If you want to finish your copper solder projects quicker than please buy this product.
Peter D. –
Sizes are limited to 3/4â and 1/2â but this little tool on a 1/4â chuck drill shaved 3-4 hours off of a 12 hour copper job. Sand clothing is needed in some respect like for chiggers on the pipe wall like foundry markings or scratches. Best for new copper pipe. Make sure to buy replacements strips and have some ring snap pliers. Highly recommend. I call it the arthritis saver.
joe soltys –
Purchased 1 then 2 more right away of these tools for our shop. We do a lot of 1/2″ (5/8″OD) copper soldering of heat exchange coils. My coil guys love them.Wire brush lasts us 3-4 weeks. Run it in reverse when it gets dull to extend the life of the wire brush.Have been using these daily for 3 months now.The 1/2″OD copper size works with 5/8″OD.
Steven –
Very impressive product
Jim M. –
Well-made and works well, however, it would be GREAT if they made it slightly longer. It cleans about 7/8 inches of pipe. Push-connect pipe fittings (such as SharkBites), which are now sold everywhere and used almost exclusively for residential fitting replacements, require either 15/16 or 1 inch of pipe to be cleaned. Therefore, I have to manually sand the remaining 1/8 inch of pipe manually when installing these fittings, which somewhat defeats the purpose of having this tool.
Andrew Choly –
If you want to finish your copper solder projects quicker than please buy this product.
Peter D. –
Sizes are limited to 3/4â and 1/2â but this little tool on a 1/4â chuck drill shaved 3-4 hours off of a 12 hour copper job. Sand clothing is needed in some respect like for chiggers on the pipe wall like foundry markings or scratches. Best for new copper pipe. Make sure to buy replacements strips and have some ring snap pliers. Highly recommend. I call it the arthritis saver.
joe soltys –
Purchased 1 then 2 more right away of these tools for our shop. We do a lot of 1/2″ (5/8″OD) copper soldering of heat exchange coils. My coil guys love them.Wire brush lasts us 3-4 weeks. Run it in reverse when it gets dull to extend the life of the wire brush.Have been using these daily for 3 months now.The 1/2″OD copper size works with 5/8″OD.
Steven –
Very impressive product
Jim M. –
Well-made and works well, however, it would be GREAT if they made it slightly longer. It cleans about 7/8 inches of pipe. Push-connect pipe fittings (such as SharkBites), which are now sold everywhere and used almost exclusively for residential fitting replacements, require either 15/16 or 1 inch of pipe to be cleaned. Therefore, I have to manually sand the remaining 1/8 inch of pipe manually when installing these fittings, which somewhat defeats the purpose of having this tool.